Tree Cutting Tips From The Professional Tree Removal Company in Woodstock, Georgia

Cutting Down Trees

Tree cutting service in Woodstock is one of the most dangerous professions that there is to do. You must learn how to properly handle and manipulate the tree removal equipment in order to maintain your safety. If you’re not able to hire a tree removal company, you’ll have to do the job yourself.

These tips may help you to keep everything running smoothly.

Use The Right Equipment for Tree Removal

Before you begin your tree cutting project, you’ll need to learn how to properly cut trees and ensure that you have the proper equipment to fell the tree.

All of your equipment must be in good condition and you will have to test and make sure that it is prior to using it. Here are the main pieces of equipment that you’ll need in order to fell your trees:

Chainsaw is vital for tree services:

The chainsaw is likely the most vital piece of equipment that you will require for felling your tree. It should have a minimum of 3.5 horsepower and it will require a 20-inch bar. This indicates how far into the tree it can penetrate, 20 inches is usually plenty large to fell most trees.

Safety Glasses for tree removal:

A lot of people don’t think about this one safety measure. However, when you’re felling trees in Woodstock, you may have some flying debris that could harm your vision if it gets into your eyes. Always wear your safety goggles when using a chainsaw.

Leg Protection from chainsaws:

Many trees have a knot in them, if you saw through this you may find that your chainsaw kicks back from the tree and hits you right in the leg.

Use knee-high boots or wear some heavy leg protectors in order to protect yourself from any injury.

1000 LB Test Rope for felling trees:

This will be tied to the tree should there be an issue. It should be three times as long as the tree is high. It’s a safety back-up that will keep you safe should the tree start to fall before you’re ready.

Take the time to look your gear over and make sure that it’s all in working order before you begin to fell the tree. Make sure that you have a few friends as well to help you out.

They can help by directing you and letting you know if the tree is about to fall the wrong way. If you’re planning on doing this yourself, it’s always wise to have some helpers with you during the process. You don’t want the tree to fall on you, your car, someone else’s car or your house.

You especially don’t want your tree to fall on a neighbor’s property or car.

Check to see how tall the tree is. Depending upon the height and the direction you want your tree to fall you’ll need to clear an area for a tree fall zone. Tie your rope to the tree near the middle or higher. Give the other end of the rope to your friends to hang on to. This way, should the tree start to fall the wrong direction the friends can hang on to it and you can help them to redirect the tree.

After you’ve set this all up, it’s time to cut a V-shaped notch in the tree. Cut this on the side of the tree that you want it to fall. It should be about knee-height and go completely to the center of the tree. It should look as if you’ve notched the tree with a shallow letter V.

Move over to the far side of your tree now and begin to slowly cut into it until you meet the notch.

As the tree begins to fall, walk away at a 45-degree angle from the tree. Be careful not to fall into the trajectory of the tree falling.

Should your tree not fall or get caught up on another tree, make sure that your friends are pulling on the rope encouraging it to fall correctly. You may need to assist them with this if the tree is very large.  Do Not Attempt this on your own if you think the job is too big.  Contact us for an evaluation of your trees and the potential dangers.

It is recommended that you hire an expert tree service in Woodstock, GA to cut it for you. However, if you plan to do this yourself, remember these tips on tree removal.

1.) Never stand right behind the tree as it begins to fall.

2.) Stumps can easily snap off and send the tree the other direction. It can cause serious injuries.

3.) Don’t’ go near the tree with the chainsaw if it won’t fall, use the rope to pull it, the tree could still snap off and harm you.

If you’re unsure of your skills, hire a pro and get it done right.  Contact us today for a free estimate.